The manufacturer of HGM grinding mill tells you that the mill is a commonly used equipment, the following HGM grinding mill manufacturer will explain to you the use and maintenance of the mill:

1. In addition to the sliding bearing used for the upper end of the main shaft, the other transmission parts of the HGM grinding mill manufacturer use rolling bearings. Therefore, it must be operated under good lubrication conditions, otherwise the bearings will be damaged and the service life will be shortened. The maintenance method is as follows: The main shaft oiling time is once per shift, but you must pay attention. When you find that the oil in the oil cup is not lost or the loss is too slow, you should immediately clean the oil passage and add 50# mechanical oil. The position of the oil cup is at the upper end of the spindle. Base bearings and roller shaft bearings are filled with 3# lithium grease once per shift with a grease gun, analyzer bearings are disassembled and cleaned once every six months, and 3# lithium grease is added enough, and lithium-based grease is added to the fan bearing chamber. grease.
2. The manufacturer of HGM grinding mill prohibits metal blocks from entering the machine, otherwise it will damage the grinding roller, grinding ring, and even the center hanger.
3. The feed should be even, and not over and under. HGM grinding mill manufacturers will block the air duct if they add too much material, reduce the output, and easily burn out the motor. Too little material will feed the output. Feeding size: when the diameter of hard materials is less than 15 mm, the diameter of soft materials can be 20 mm, and it is strictly forbidden to add bulk materials into the machine.
4. Air volume adjustment: The air volume control valve of the HGM grinding mill manufacturer located on the air inlet pipe of the fan is generally opened to a higher position and adjusted appropriately according to the fineness and output requirements. The regulating valve located on the exhaust pipe of the exhaust gas outlet can be adjusted to the inlet where there is no dust spray. The air volume is small and the fineness is high. HGM grinding mill manufacturers should pay attention to the fact that if the air volume is too small, materials are likely to settle in the air duct under the host. Please adjust it appropriately.
5. Fineness adjustment. According to the size, hardness, water content, and specific gravity of the material, the processing thickness is also different. The HGM grinding mill manufacturer can adjust the upper analyzer for high speed, high fineness, low speed, and fineness. low. Increase the fineness, the output will be reduced accordingly, if the fan speed is not up to the requirements, the user should be able to control flexibly.
6. The scrap limit of the grinding roller and ring, the remaining minimum wall thickness shall not be less than 10mm.
7. When stopping, stop feeding first, and the host will continue to grind the remaining abrasive. After about one minute, you can turn off the host motor and analyzer motor, stop the grinding work, and then stop the fan motor. In order to blow off the remaining powder.