HGM grinding mill is the main equipment needed in the grinding process, so what problems should be paid attention to during use? The following HGM grinding mill manufacturers will give you an inventory of 7 aspects that need to be paid attention to during use:

1. In the process of using HGM grinding mill, a fixed person should be responsible for it, and the operator must have a certain technical level. Before installation, the operator must carry out the necessary technical training to make them understand the principle and performance of the HGM grinding mill, and be familiar with the operating procedures.
2. Since HGM grinding mills usually work outdoors, the crushed materials are some large ore, so the operators of HGM grinding mills must always pay attention to strictly prohibit metal pieces from entering the machine. If found, stop and take them out immediately, otherwise it will be damaged. Grinding rollers and grinding rings;
3. In the use of HGM grinding mill, it is necessary to strictly control the moisture of the material. Materials with too high water content can easily cause the fine powder in the mill to occupy the grinding body due to excessive viscosity, which will seriously affect the quality and output of the product.
4. The feed must be carried out in accordance with the prescribed standards, otherwise the final particle size will be uneven, coarse, and fine, which will affect the grinding effect.
5. It is necessary to grasp the adjustment of air volume, and adjust appropriately according to the fineness and output requirements; whether the air volume is too large or the air volume is too small, it will have a bad effect on the grinding effect of the HGM grinding mill.
6. After the mill is used for a period of time, it should be overhauled. At the same time, the wearing parts such as the grinding roller, grinding ring and blade should be overhauled and replaced. The connecting bolts and nuts of the grinding roller device should be carefully checked before and after use to see if there is any looseness. Phenomenon, is there enough lubricating grease?
7. Master the correct method of stopping. Stop feeding before stopping. After a while, the power can be cut off when there is no remaining material in the HGM grinding mill. After stopping the grinding work, stop the fan motor. , In order to blow off the remaining powder.