VSI sand making machine manufacturer will show you: three types of maintenance of sand making machine
Jul 28,2021
The VSI sand making machine manufacturer tells you that the planned maintenance of the sand making machine can be divided into three types: minor repair, medium repair and overhaul.
VSI sand making machine manufacturers tell you that minor repairs and intermediate repairs are the main repair methods. Through minor repairs and intermediate repairs, the equipment is maintained during the two major repairs to make it work normally, and the content of the major repairs is determined. The VSI sand making machine manufacturer tells you that the interval between two repairs mentioned below is calculated on the basis of three shifts a day.
Sand making machine minor repair work: VSI sand making machine manufacturer tells you to check and repair the adjustment device, adjust the clearance of the unloading port, replace the worn liner and reasoning board, repair and replace the rotating parts, clean the individual parts of the crusher, replace the lubricating oil, repair and adjust Lubrication system, etc.
The VSI sand making machine manufacturer tells you that the interval between minor repairs of the sand making machine depends on the operation of the equipment, usually every half a month to once a month.
The main content of the intermediate repair: including all the content of the minor repair. In addition, replace worn liners, bushings, tie rods and linings; check, rotate, dive and cast eccentric bushings, connecting rod head bearings and moving jaw bearings, generally once a year.
The main contents of this sand making machine overhaul are as follows:
The VSI sand making machine manufacturer tells you to include everything in the middle sleeve of the sand making machine. In addition, the eccentric shaft and jaw mandrel of the crusher should be replaced or rotated; the bus bar alloys on both sides of the head should be cast; all worn parts should be replaced and repaired; the whole machine should be rectified, and the equipment technical reform should be carried out.
The VSI sand making machine manufacturer tells you that the interval between two overhauls of the sand making machine mainly depends on the wear of the eccentric shaft and the moving jaw mandrel. It is usually required every four years.
Related Posts